The Quick Setup includes common configurations like time, date, thermostat type, dirty filter timer, etc. Once this is completed, you have to set the Quick Setup Checklist to “done”, or it will continue to display that it needs to be completed. Network Setup is a submenu for specific network settings like CCN or BACnet. The SystemVu is defaulted to BACnet. When this is completed, make sure to set the Network Checklist to “done”.
During the setup process, the “service test function” is used to check compressors, heating, indoor and outdoor fans, power exhaust, economizer, crankcase heaters, and the alarm relay. This function is also used for troubleshooting the system in case there is an alarm or break down. To enter the service test function, press the TEST button on the SystemVu display at any time to access the Test menu. The service test mode is turned ON or OFF at the unit display. Once turned ON, other entries may be made with the SystemVu control. Service Mode Test will automatically turn off automatically, based on keypad inactivity or the test has completed and timed out. When using the service test function, operating limits for cooling, heating, and the economizer are ignored. Time guards for staging or delaying are limited to one minute.
System Auto Test when turned on will start with the Independent outputs, and this will turn components in the unit on and off. For example: crankcase heater, outdoor fans, indoor fan, etc. After testing these components, it then starts the cooling auto test, and then the heating auto test. Don’t forget, when this is completed, set to “done”. You will also be asked if you want the data entered into a service report.
When connecting the equipment to a thermostat, the SystemVu controller can interface with third party controls. When using a third party control, the control type has to be configured in the SystemVu controller. This configuration is only if the unit control type is a thermostat. There are four choices to choose from:
0 = CONV 2C2H – Conventional Thermostat 2 stage cool and 2 stage heat.
1 = DIGI 2C2H – Digital Thermostat 2 stage cool and 2 stage heat.
2 = CONV 3C2H – Conventional Thermostat 3 stage cool and 2 stage heat. This is the default setting.
3 = DIGI 3C2H – Digital Thermostat 3 stage cool and 2 stage heat.

SystemVu also has optional configurable inputs. There are five physical board switch inputs (discrete inputs) and three physical board analog inputs. Here are inputs of each: